DiodeCommunity report
Rock
Shared by @leighsmeltedmoments on Atomm
Important safety notice
Settings are starting points — always run a test cut on scrap before your final piece. Follow your manufacturer's guidance, wear eye protection, and ensure proper ventilation.
Laser Settings
Engrave · Vector · Flat SurfacePower
100
Speed
100
LPC
150
Passes
2
defocus
3 mm
Engraved a rock with a simple picture. Depending on the type of rock, results may vary. For example, I found a white rock and engraved with the same settings, and it was a faint outline. Next time if I engraved a white rock, I would place film or a spray on before hand to help with the clarity and visibility of the engraving.
Community Feedback
No votes yet — be the first to report how these settings worked.
Export
xTool machine: open it straight in xTool Studio, or download a .mxs (Studio → Materials → Import).
Sponsored
Shop xTool lasers and UV printers
Every xTool machine in this library, with our discount code.
Code ERIK100: $100 off $1,699+ (or ERIK80: $80 off $999+)
Shop xTool →Machine Context
BrandxTool
ModelM1
Laser typeDiode
Wattage10W
Compare against your own machine before treating these as a starting point.
Material Details
MaterialRock
Shop machine — xTool →
Code ERIK100 — $100 off $1,699+ (or ERIK80 — $80 off $999+)
Provenance
Source type
Community report
Shared by a maker in the community. Helpful for context, but not verified for every setup.