DiodeCommunity report
Glass Bottle
Shared by @Patrik Adolfsson on Atomm
Important safety notice
Settings are starting points — always run a test cut on scrap before your final piece. Follow your manufacturer's guidance, wear eye protection, and ensure proper ventilation.
Laser Settings
Engrave · Vector · Flat SurfacePower
70
Speed
150
LPC
140
Passes
1
Crosshatch
On
defocus
3 mm
Custom glass bottle.
Flat engraving
I diluted tempera paint with water at approximately a 6:1 ratio, making the mixture very thin and runny.
I applied it using a simple plastic spray bottle, which produced a very light and even coating. Each coat was dried with a hair dryer, which only took about a minute.
Power: 70%
Speed: 150
Pass: 1
Lines per cm: 140
Engraving Angle: 0
Cross hatch: On
Defocus +2mm upwards
Community Feedback
No votes yet — be the first to report how these settings worked.
Export
xTool machine: open it straight in xTool Studio, or download a .mxs (Studio → Materials → Import).
Sponsored
All American Print Supply
DTF and UV printers, supplies and xTool machines.
Code FOUNDRY: 5% off, machines included
Shop AAPS →Machine Context
BrandxTool
ModelF2 Ultra
Laser typeDiode
Wattage40W
Compare against your own machine before treating these as a starting point.
Material Details
MaterialGlass Bottle
Shop machine — xTool →
Code ERIK100 — $100 off $1,699+ (or ERIK80 — $80 off $999+)
Provenance
Source type
Community report
Shared by a maker in the community. Helpful for context, but not verified for every setup.