CO2Community report

Delrin / Acetal - 3mm

Shared by Community — To Be Tested

Important safety notice

Settings are starting points — always run a test cut on scrap before your final piece. Follow your manufacturer's guidance, wear eye protection, and ensure proper ventilation.

Laser Settings

Cut · Vector

Power

100

Speed

12%

Passes

Frequency

100%

Thickness

3mm

scale

Epilog % (Speed / Power / Frequency)

derived from

Epilog Acrylic cutting 1/8", adjusted denser

to be tested

yes

⚠️ TO BE TESTED — not yet run on this machine. Derived from Epilog Acrylic cutting 1/8", adjusted denser. Speed and Power are Epilog % — not mm/s. Run a test grid on scrap and correct this entry.

More Delrin settings

Same material on Epilog Fusion Pro 48. Engrave stays the same regardless of thickness; cut changes with thickness.

Engrave (any thickness)

P25 S100%

Cut by thickness

3mm · P100 S12% · this one

Community Feedback

No votes yet — be the first to report how these settings worked.

Export

LightBurn machine — exports as .clb, no retyping.

Test Grid Generator

A power × speed sweep with this setting (P100 · S12) in the center square — dial it in on scrap.

Machine Context

BrandEpilog

ModelFusion Pro 48

Laser typeCO2

Wattage120W

Compare against your own machine before treating these as a starting point.

Material Details

MaterialDelrin / Acetal - 3mm

Size3mm

Provenance

Source type

Community report

Shared by a maker in the community. Helpful for context, but not verified for every setup.

License

CC0 (Public Domain)