CO2Community report

Walnut - 6mm

Shared by Community — To Be Tested

Important safety notice

Settings are starting points — always run a test cut on scrap before your final piece. Follow your manufacturer's guidance, wear eye protection, and ensure proper ventilation.

Laser Settings

Engrave · Bitmap

Power

100

Speed

80%

DPI

500

Passes

Thickness

6mm

scale

Epilog % (Speed / Power / Frequency)

derived from

Epilog Wood, adjusted denser/darker

to be tested

yes

⚠️ TO BE TESTED — not yet run on this machine. Derived from Epilog Wood, adjusted denser/darker. Speed and Power are Epilog % — not mm/s. Run a test grid on scrap and correct this entry. Dark stock — engrave contrast is low; consider a deeper pass.

More Walnut settings

Same material on Epilog Fusion Pro 48. Engrave stays the same regardless of thickness; cut changes with thickness.

Engrave (any thickness)

6mm · P100 S80% · this one

Cut by thickness

6mm · P100 S8%

Community Feedback

No votes yet — be the first to report how these settings worked.

Export

LightBurn machine — exports as .clb, no retyping.

Test Grid Generator

A power × speed sweep with this setting (P100 · S80) in the center square — dial it in on scrap.

Machine Context

BrandEpilog

ModelFusion Pro 48

Laser typeCO2

Wattage120W

Compare against your own machine before treating these as a starting point.

Material Details

MaterialWalnut - 6mm

Size6mm

Provenance

Source type

Community report

Shared by a maker in the community. Helpful for context, but not verified for every setup.

License

CC0 (Public Domain)