CO2Community report

Walnut

Shared by Community Import

Important safety notice

Settings are starting points — always run a test cut on scrap before your final piece. Follow your manufacturer's guidance, wear eye protection, and ensure proper ventilation.

Laser Settings

Engrave · Bitmap

Power

Speed

400 mm/s

Line Interval

0.085

Community-aggregated import — a starting point only. Test on scrap first, and report it if the setting doesn't work.

More Walnut settings

Same material on Aeon Laser MIRA 7. Engrave stays the same regardless of thickness; cut changes with thickness.

Engrave (any thickness)

P75 S400 mm/s · this one

Cut by thickness

2mm · P60 S50 mm/s 3.175mm · P90 S13.3 mm/s 6.35mm · P90 S7 mm/s

Community Feedback

No votes yet — be the first to report how these settings worked.

Export

LightBurn machine — exports as .clb, no retyping.

Test Grid Generator

A power × speed sweep with this setting (P75 · S400) in the center square — dial it in on scrap.

Machine Context

BrandAeon Laser

ModelMIRA 7

Laser typeCO2

Wattage60W

Compare against your own machine before treating these as a starting point.

Material Details

MaterialWalnut

Provenance

Source type

Community report

Shared by a maker in the community. Helpful for context, but not verified for every setup.

License

CC0 (Public Domain)