Pick your machine
6 machines have Kraft Paper settingsCO2Community report
Kraft Paper
Shared by Community — To Be Tested
Important safety notice
Settings are starting points — always run a test cut on scrap before your final piece. Follow your manufacturer's guidance, wear eye protection, and ensure proper ventilation.
Laser Settings
Cut · VectorPower
20
Speed
70%
Passes
1
Frequency
50%
scale
Epilog % (Speed / Power / Frequency)
derived from
Epilog Mat Board cutting, adjusted thinner
to be tested
yes
⚠️ TO BE TESTED — not yet run on this machine. Derived from Epilog Mat Board cutting, adjusted thinner. Speed and Power are Epilog % — not mm/s. Run a test grid on scrap and correct this entry.
Community Feedback
No votes yet — be the first to report how these settings worked.
Export
LightBurn machine — exports as .clb, no retyping.
Sponsored
All American Print Supply
DTF and UV printers, supplies and xTool machines.
Code FOUNDRY: 5% off, machines included
Shop AAPS →Test Grid Generator
A power × speed sweep with this setting (P20 · S70) in the center square — dial it in on scrap.
Machine Context
BrandEpilog
ModelFusion Pro 48
Laser typeCO2
Wattage120W
Compare against your own machine before treating these as a starting point.
Material Details
MaterialKraft Paper
Provenance
Source type
Community report
Shared by a maker in the community. Helpful for context, but not verified for every setup.
License
CC0 (Public Domain)
No rights reserved, free to use.