CO2Community report

Acrylic Panel

Shared by Community Import

Important safety notice

Settings are starting points — always run a test cut on scrap before your final piece. Follow your manufacturer's guidance, wear eye protection, and ensure proper ventilation.

Laser Settings

Engrave · Bitmap

Power

Speed

400 mm/s

Line Interval

0.056

Community-aggregated import — a starting point only. Test on scrap first, and report it if the setting doesn't work.

More Acrylic Panel settings

Same material on Aeon Laser Nova 10. Engrave stays the same regardless of thickness; cut changes with thickness.

Engrave (any thickness)

P36 S400 mm/s · this one

Cut by thickness

3.175mm · P90 S22.2 mm/s 4mm · P60 S16.7 mm/s 5mm · P60 S13.3 mm/s 6.35mm · P90 S11.1 mm/s 8mm · P60 S5.6 mm/s 10mm · P60 S3.3 mm/s 20mm · P60 S1.1 mm/s

Community Feedback

No votes yet — be the first to report how these settings worked.

Export

LightBurn machine — exports as .clb, no retyping.

Test Grid Generator

A power × speed sweep with this setting (P36 · S400) in the center square — dial it in on scrap.

Machine Context

BrandAeon Laser

ModelNova 10

Laser typeCO2

Wattage100W

Compare against your own machine before treating these as a starting point.

Material Details

MaterialAcrylic Panel

Provenance

Source type

Community report

Shared by a maker in the community. Helpful for context, but not verified for every setup.

License

CC0 (Public Domain)