DiodeCommunity report

1/8"(3mm) MDF Board

Shared by @carebear20023 on Atomm

Important safety notice

Settings are starting points — always run a test cut on scrap before your final piece. Follow your manufacturer's guidance, wear eye protection, and ensure proper ventilation.

Laser Settings

Engrave · Bitmap · Flat Surface

Power

Speed

239

LPC

Passes

Thickness

3mm

I used 3mm MDF Board first time use for me , and the design was made with the help of AI . The object is a Pregnancy loss awareness butterfly ribbon made this one a magnet however this also hits close to home for me ! I hope everyone enjoys making this , and good luck ! I used Metallic Acrylic Paint Markers to give it a little shine! Also October is Pregnancy loss awareness!

More 1/8"(3mm) MDF Board settings

Same material on xTool M2. Engrave stays the same regardless of thickness; cut changes with thickness.

Community Feedback

No votes yet — be the first to report how these settings worked.

Export

xTool machine: open it straight in xTool Studio, or download a .mxs (Studio → Materials → Import).

Machine Context

BrandxTool

ModelM2

Laser typeDiode

Wattage20W

Compare against your own machine before treating these as a starting point.

Material Details

Material1/8"(3mm) MDF Board

Size3mm

SupplierxTool

Buy this material →

Buy from xTool →

Code ERIK100 — $100 off $1,699+ (or ERIK80 — $80 off $999+)

Shop machine — xTool →

Code ERIK100 — $100 off $1,699+ (or ERIK80 — $80 off $999+)

Provenance

Source type

Community report

Shared by a maker in the community. Helpful for context, but not verified for every setup.

Source

Shared by @carebear20023 in Atomm, xTool's community

View the original post →

Pick your machine