Pick your machine
12 machines have Coir Doormat settings
CO2Community report
Coir Doormat
Shared by Community — To Be Tested
Important safety notice
Settings are starting points — always run a test cut on scrap before your final piece. Follow your manufacturer's guidance, wear eye protection, and ensure proper ventilation.
Laser Settings
Engrave · BitmapPower
100
Speed
60%
DPI
200
Passes
1
scale
Epilog % (Speed / Power / Frequency)
derived from
Epilog Wood deep engraving, adjusted coarse fibre
to be tested
yes
⚠️ TO BE TESTED — not yet run on this machine. Derived from Epilog Wood deep engraving, adjusted coarse fibre. Speed and Power are Epilog % — not mm/s. Run a test grid on scrap and correct this entry. Very smoky. Wet the mat lightly to cut flare-ups.
Community Feedback
No votes yet — be the first to report how these settings worked.
Export
LightBurn machine — exports as .clb, no retyping.
Sponsored
Shop xTool lasers and UV printers
Every xTool machine in this library, with our discount code.
Code ERIK100: $100 off $1,699+ (or ERIK80: $80 off $999+)
Shop xTool →Test Grid Generator
A power × speed sweep with this setting (P100 · S60) in the center square — dial it in on scrap.
Machine Context
BrandEpilog
ModelFusion Pro 48
Laser typeCO2
Wattage120W
Compare against your own machine before treating these as a starting point.
Material Details
MaterialCoir Doormat
Provenance
Source type
Community report
Shared by a maker in the community. Helpful for context, but not verified for every setup.
License
CC0 (Public Domain)
No rights reserved, free to use.