CO2Maker Foundry
Rubber
Gray Stamp Engraving
Shared by Maker Foundry
Important safety notice
Settings are starting points — always run a test cut on scrap before your final piece. Follow your manufacturer's guidance, wear eye protection, and ensure proper ventilation.
Laser Settings
Engrave · Vector · Flat SurfacePower
80
Speed
300
Line Interval
0.032
Frequency
8000
Pulse Width
140
Gray Stamp Engraving | LinkPath: 55w RF/Rubber/Gray Stamp Engraving
More Rubber settings
Same material on Thunder Laser Bolt Pro 55. Engrave stays the same regardless of thickness; cut changes with thickness.
Engrave (any thickness)
P80 S300 · this one
Cut by thickness
Community Feedback
No votes yet — be the first to report how these settings worked.
Test Grid Generator
A power × speed sweep with this setting (P80 · S300) in the center square — dial it in on scrap.
Machine Context
BrandThunder Laser
ModelBolt Pro 55
Laser typeCO2
Wattage55W
Compare against your own machine before treating these as a starting point.
Material Details
MaterialRubber
Color / FinishGray Stamp Engraving
Provenance
Source type
Maker Foundry
Shared by Maker Foundry. A starting point — test on scrap before your final piece, as your machine and material may differ.
License
CC0 (Public Domain)
No rights reserved, free to use.