Pick your machine

13 machines have Brass settings

3 settings

Fiber/InfraredCommunity report

Brass

Coin - deep

Shared by Community — To Be Tested

Important safety notice

Settings are starting points — always run a test cut on scrap before your final piece. Follow your manufacturer's guidance, wear eye protection, and ensure proper ventilation.

Laser Settings

Engrave · Vector · Flat Surface

Power

100

Speed

20%

Line Interval

0.0015

Passes

Frequency

Pulse Width

Waveform 15

Engr. Angle

45°

Crosshatch

scale

Epilog % (Speed / Power / Frequency); Spacing in inches

waveform

fiber type

MOPA

spacing in

0.0015

spacing mm

0.0381

derived from

Tier A Metals - Deep Engraving (F254)

to be tested

yes

⚠️ TO BE TESTED — not yet run on this machine. Derived from Tier A Metals - Deep Engraving (F254). Speed / Power / Frequency are Epilog %, Spacing is in inches, Waveform is the MOPA pulse-width index (higher = longer pulse). The mm/s → Speed % step is the weakest part of this estimate — Epilog's speed scale is non-linear. Run a test grid and correct this entry. Multiple cycles. Slow speeds erupt material rather than ablate it.

More Brass settings

Same material on Epilog Fusion Pro Galvo. Engrave stays the same regardless of thickness; cut changes with thickness.

Engrave (any thickness)

P100 S20% · this oneP100 S20%

Community Feedback

No votes yet — be the first to report how these settings worked.

Export

LightBurn machine — exports as .clb, no retyping.

Test Grid Generator

A power × speed sweep with this setting (P100 · S20) in the center square — dial it in on scrap.

Machine Context

BrandEpilog

ModelFusion Pro Galvo

Laser typeFiber/Infrared

Wattage30W

Compare against your own machine before treating these as a starting point.

Material Details

MaterialBrass

Color / FinishCoin - deep

Provenance

Source type

Community report

Shared by a maker in the community. Helpful for context, but not verified for every setup.

License

CC0 (Public Domain)