Pick your machine
24 machines have Leather settingsFiber/InfraredCommunity report
Leather
Natural
Shared by Community — To Be Tested
Important safety notice
Settings are starting points — always run a test cut on scrap before your final piece. Follow your manufacturer's guidance, wear eye protection, and ensure proper ventilation.
Laser Settings
Engrave · Vector · Flat SurfacePower
25
Speed
100%
Line Interval
0.002
Passes
1
Frequency
1%
Pulse Width
Waveform 10
Engr. Angle
45°
scale
Epilog % (Speed / Power / Frequency); Spacing in inches
waveform
10
fiber type
MOPA
spacing in
0.002
spacing mm
0.0508
derived from
Tier A Painted Metal polish, adjusted for hide
to be tested
yes
⚠️ TO BE TESTED — not yet run on this machine. Derived from Tier A Painted Metal polish, adjusted for hide. Speed / Power / Frequency are Epilog %, Spacing is in inches, Waveform is the MOPA pulse-width index (higher = longer pulse). The mm/s → Speed % step is the weakest part of this estimate — Epilog's speed scale is non-linear. Run a test grid and correct this entry. Fiber marks leather far less readily than CO2 — expect a lighter tone.
Community Feedback
No votes yet — be the first to report how these settings worked.
Export
LightBurn machine — exports as .clb, no retyping.
Sponsored
Shop xTool lasers and UV printers
Every xTool machine in this library, with our discount code.
Code ERIK100: $100 off $1,699+ (or ERIK80: $80 off $999+)
Shop xTool →Test Grid Generator
A power × speed sweep with this setting (P25 · S100) in the center square — dial it in on scrap.
Machine Context
BrandEpilog
ModelFusion Pro Galvo
Laser typeFiber/Infrared
Wattage30W
Compare against your own machine before treating these as a starting point.
Material Details
MaterialLeather
Color / FinishNatural
Provenance
Source type
Community report
Shared by a maker in the community. Helpful for context, but not verified for every setup.
License
CC0 (Public Domain)
No rights reserved, free to use.