Maker Foundry

Pick your machine

22 machines
Epilog
Fusion Pro 48
2 settings
Epilog
Fusion Pro Galvo
4 settings
JPT
60W MOPA Fiber
4 settings
OneLaser
38W RF
1 setting
OneLaser
55W CO2
1 setting
OneLaser
80W CO2
1 setting
OneLaser
100W CO2
1 setting
OneLaser
130W CO2
1 setting
OneLaser
150W CO2
1 setting
Sculpfun
S9
2 settings
Thunder Laser
Bolt Pro 55
2 settings
Thunder Laser
Nova 60
2 settings
Thunder Laser
Nova 80
2 settings
Thunder Laser
Nova 100
2 settings
D1 Pro
4 settings
F1
4 settings
F1 Ultra
4 settings
F2
18 settings
F2 Ultra
3 settings
xTool
F2 UV
6 settings
P2 / P2S
6 settings
P3
3 settings
Fiber/InfraredCommunity report

Leatherette

Black - marks red

Shared by Community — To Be Tested

Important safety notice

Settings are starting points — always run a test cut on scrap before your final piece. Follow your manufacturer's guidance, wear eye protection, and ensure proper ventilation.

Laser Settings

Engrave · Vector · Flat Surface
Power
15
Speed
100%
Line Interval
0.0008
Passes
2
Frequency
1%
Pulse Width
Waveform 10
Engr. Angle
45°
scale
Epilog % (Speed / Power / Frequency); Spacing in inches
waveform
10
fiber type
MOPA
spacing in
0.0008
spacing mm
0.0203
derived from
Maker Foundry JPT 60W MOPA (11p / 1500mm/s / 80kHz / 2 passes)
to be tested
yes
⚠️ TO BE TESTED — not yet run on this machine. Derived from Maker Foundry JPT 60W MOPA (11p / 1500mm/s / 80kHz / 2 passes). Speed / Power / Frequency are Epilog %, Spacing is in inches, Waveform is the MOPA pulse-width index (higher = longer pulse). The mm/s → Speed % step is the weakest part of this estimate — Epilog's speed scale is non-linear. Run a test grid and correct this entry. Black leatherette marks red, not white — that is the substrate showing.

More Leatherette settings

Same material on Epilog Fusion Pro Galvo. Engrave stays the same regardless of thickness; cut changes with thickness.

Engrave (any thickness)
P15 S100% · this oneP30 S70%P40 S70%P30 S70%

Community Feedback

No votes yet — be the first to report how these settings worked.

Export

LightBurn machine — exports as .clb, no retyping.

Sponsored
All American Print Supply

DTF and UV printers, supplies and xTool machines.

Code FOUNDRY: 5% off, machines included

Shop AAPS →

Test Grid Generator

A power × speed sweep with this setting (P15 · S100) in the center square — dial it in on scrap.

Machine Context

BrandEpilog
ModelFusion Pro Galvo
Laser typeFiber/Infrared
Wattage30W

Compare against your own machine before treating these as a starting point.

Material Details

MaterialLeatherette
Color / FinishBlack - marks red

Provenance

Source type
Community report

Shared by a maker in the community. Helpful for context, but not verified for every setup.

License

CC0 (Public Domain)

No rights reserved, free to use.